The reviews are automatic translation.
Dyeing of polyester fabric (petals)
On 2016-04-15 19:39:39
Center had been using a syringe into a hole how dyed put a dye that the dye a lot of dough for a short tip of the syringe for the Company to stain the fabric of the recent polyester manufacturers of artificial flowers it was difficult, but we were able to dye a lot of petals by the use of this nozzle. Speaking greed, is the length of the nozzle also want shorter than it is now.
The nozzle of the adhesive container
On 2015-12-09 13:48:35
Drug injected into the trees
On 2015-10-19 14:07:15
Use the drug injected into the holes of the beetles in the trees.
It is ideal for a little bending use the tip.
100 is also the same as price size is in the thing and looks dated injector of the average I think the more expensive.
Inhalation work of liquid
On 2014-11-06 16:10:42
Also created a robust, needle also long, is a handy nozzle that it can also be neatly inhalation excess liquid into a deep bottle bottom.
Adhesive injection and coating
On 2014-05-31 14:55:32
Size (both length and thickness) is may inexpensive appropriate and price.
However, it more than in the last minute Usable in bonderizing E set
High adhesive viscosity - Quick Mender, etc. - in not suitable at all.
Acrylic adhesive - methylene chloride, and the like - might be more small-diameter will want at the time of use.
It is perfect If they can get one step ahead thin and thick earlier.
Fluorescent agent injection for the piping internal flaw fluorescent flaw detection, etc.
On 2013-02-15 13:44:22
Is a fluorescent agent is spilling the very settlement is, but you can well injection without spilling a drop and this is. Work efficiency went up suddenly.
On 2012-11-06 15:52:07
Since the number of one unit is too large at ten, I want you to also sell of about five.
Work out at once continuously the ink as a dot.
On 2012-07-01 04:25:37
It did not become almost useless too thick. I was also quite experiment towards the viscosity, but did not work in this thickness.
I hope something more narrow.
Injection of adhesive
On 2011-10-20 00:15:41
Thick, too thick. Outline is also 1.3mm. This can not be used to fine workmanship. Could you sell much of the 0.5mm in profile
To resin injected into the cracks of the concrete.
On 2011-09-19 19:24:14
Fit perfectly to Terumo syringe was able to use comfortably. Tip can be injected into the narrow gap if any product became flat. This time I tried to use to cut like a needle the tip did not go again there is a leak from the tip well. We were able to work comfortably if there is such a thing of plastic parts to be attached to the tip of Aron Alpha.